Cross stitch guides › Finishing a bookmark
How to finish a cross stitch bookmark
A bookmark has to lie flat, survive being pushed into a book and look the same on both sides. Folded edges and a felt back do all three, and a tassel in one of the design’s own threads finishes it.
What you need
- Your stitching, washed and pressed.
- Felt for the back: thin felt keeps the bookmark slim.
- Thread for the tassel: about 5 m (5½ yd) of six-strand cotton in one of the design’s colors.
- A piece of card 3 inches (7.5 cm) wide to wind the tassel on.
- Sewing thread and a needle, or fabric glue.
Each bookmark pattern on this site gives the finished size and the felt to cut for its own design, under “Finishing it”. For your own design, the fabric calculator gives the stitched size to start from.
Step by step
- Mark the edge. Count two bare rows out from the stitching on every side. The holes just beyond them are the fold line.
- Trim. Cut the Aida ½ inch (1.3 cm) beyond the fold line all round.
- Fold and press. Fold the margin to the back along the line, the long sides first, then the short ends, and press each fold with a warm iron. Trim the corners of the margin at an angle so they lie flat.
- Cut the felt a little smaller than the folded piece, so it does not show from the front.
- Join them. Lay the felt over the back, covering the folded edges, and whipstitch round the edge with thread that matches the fabric, or glue it.
- Make the tassel. Wrap the thread about 30 times round the card. Slide a short length under the wraps at the top and tie it tight. Cut the wraps at the bottom. A little way below the tie, wind a thread round all the strands several times to make the neck, and knot it. Trim the ends level.
- Attach it to the middle of the bottom edge with the tie thread, stitched through the felt and fabric together.
No folding: Aida band
Aida band is Aida sold as a ribbon with woven edges that do not fray. Stitch the design on a band a few stitches wider than it, and the long edges are already finished: only the ends need folding before you back it with felt.
Mistakes that are easy to avoid
- Folding on the stitching. Two bare rows keep the fold clear of the last stitches.
- Thick felt. A bookmark wants to be thin. Use thin felt, or iron-on interfacing for the thinnest finish.
- Too much glue. It stiffens the bookmark and can soak through. Stitching the back is more flexible.
- A heavy tassel. Thirty wraps is plenty; a thicker tassel pulls the bookmark out of the book.
Questions people ask
Can I laminate a cross stitch bookmark?
It is not a good idea: the heat flattens the stitches and the plastic traps any moisture. A felt back keeps it flat enough.
Which thread for the tassel?
One of the colors in the design, usually the one it uses most, so the tassel looks like part of it.
How do I stop the Aida fraying while I stitch?
Fold masking tape over the edges, or zigzag them on a sewing machine. Trim the edges off before finishing.
More guides
- How to wash and pressClean a finished piece and press it without flattening the stitches.
- Finishing in a hoopMount a finished piece in a hoop with a neat, covered back.
- Finishing an ornamentTurn a small piece into a flat, felt-backed ornament with a hanging loop and a corded edge.
- How to frame cross stitchChoose the frame size, lace the piece over board, and keep the glass off the stitches.
- How to cross stitchThe whole craft from the first stitch to the last, for complete beginners.
- Fabric count explainedWhat 14 count means, and how count changes the size of everything.
- Cross stitch glossary58 terms in plain words.