Cross stitch guides › Finishing in a hoop
How to finish cross stitch in a hoop
A hoop is the quickest way to turn a finished piece into something you can hang. Done well, the front is drum-tight and the back is closed and tidy. It takes about half an hour.
What you need
- A hoop of the right size. The design must fit inside the circle with some fabric to spare at the corners: the hoop size calculator works it out from your pattern.
- Your piece, washed and pressed.
- Strong sewing thread, a needle and scissors. Cut the thread about three times as long as the distance around the hoop, so one length does the whole gather.
- Optional: a circle of felt for the back, and a ribbon to hang it.
Step by step
- Center the design. Loosen the screw and separate the rings. Lay the fabric over the inner ring, design up, and move it until the design sits in the middle. Check from directly above.
- Fit the outer ring with the screw at the top. Push it down evenly and tighten the screw a little.
- Tighten in turns. Pull the fabric gently at the top and bottom, then left and right, then tighten the screw a little more. Repeat until the fabric is tight like a drum. Pull along the weave, never on the diagonal, or the design will distort.
- Check it is straight. A row of stitches should run level across the hoop. Adjust before the final tighten.
- Trim. Cut the fabric in a circle about 1 to 1.5 inches (2.5 to 4 cm) beyond the hoop.
- Gather the back. With strong thread, sew a line of running stitches around the edge of the trimmed fabric, about half an inch from the cut. Pull the thread so the fabric draws in behind the hoop like a drawstring bag, and knot it firmly.
- Lace the back (optional, for a piece that must stay tight for years). With a second long thread, make long stitches straight across the back from one side of the gathered fabric to the other, like the spokes of a wheel, pulling each one snug. Catch the fabric between the hoop and the gathering line, not at the cut edge, so the stitches cannot pull through. Lacing stops the front going slack over time.
- Cover the back (optional). Draw around the inner ring on a piece of felt and cut out the circle. Stitch it to the gathered fabric with small whip stitches or blanket stitch around the edge, catching both the felt and the fabric.
- Hang it. Tie a ribbon through the screw fitting.
Choosing and preparing the hoop
- Wood or bamboo hoops are the classic display choice. Sand any rough spots first so they cannot snag.
- Paint or stain the outer ring before mounting, and let it dry fully.
- For a firmer grip, wrap the inner ring with cotton tape. It also protects the fabric.
Mistakes that are easy to avoid
- A hoop that only just fits. The corners of the design reach further than the sides. Measure corner to corner.
- Trimming too close. Less than an inch leaves nothing to gather.
- Glue on the fabric. Many quick tutorials glue the fabric or the felt to the hoop. It is fast, but glue yellows with age and cannot be undone. Stitching the back takes ten minutes longer and can always be taken apart.
- Pulling on the diagonal. It stretches the weave and tilts the stitches.
Questions people ask
What size hoop do I need?
Wider than the design measured corner to corner, plus about an inch. A 4 × 3 inch design needs a 6 inch hoop.
Do I have to cover the back?
No. A neatly gathered back is a finished back. Felt simply hides the gathers and protects the thread ends, which is worth doing for a gift.
Can I leave the piece in the hoop I stitched it in?
Yes, if it is clean and the right size. Many people stitch in a plain hoop and display in a nicer one.
Will the hoop damage the fabric over time?
A hoop holds fabric under tension, so for an heirloom piece a frame with acid-free mounting is kinder. For most projects a hoop is fine for many years.
More guides
- How to wash and pressClean a finished piece and press it without flattening the stitches.
- How to frame cross stitchChoose the frame size, lace the piece over board, and keep the glass off the stitches.
- How to cross stitchThe whole craft from the first stitch to the last, for complete beginners.
- Fabric count explainedWhat 14 count means, and how count changes the size of everything.
- Aida, evenweave and linenHow the three fabrics differ and which to choose.
- How to find the centerTwo reliable ways to start in the middle so the design sits straight.
- Cross stitch glossary58 terms in plain words.