Cross stitch guides › How to cross stitch
How to cross stitch
Cross stitch is one stitch, an X, repeated on a fabric that has a hole for every corner. If you can count to ten and thread a needle, you can do it. This page takes you from nothing to a finished piece.
What you need
- Fabric: 14 count Aida. It is stiff, the holes are easy to see, and almost every beginner pattern is written for it.
- Thread: six-strand cotton (often called floss). You will use two strands at a time.
- Needle: a size 24 tapestry needle. It has a blunt tip that slides into the holes instead of splitting the fabric.
- Scissors, and a hoop if you like one. A hoop keeps the fabric flat; many people stitch Aida without one.
- A pattern. Start small: a design under 50 stitches each way can be finished in a few evenings.
Not sure about sizes? The needle and strands chart gives the right needle and strand count for any fabric, and the fabric calculator tells you how big a piece to cut.
Get the fabric ready
- Cut it bigger than the design. Leave 3 inches (7.5 cm) of spare fabric on every side.
- Stop the edges fraying. Aida frays as you handle it. Fold masking tape over the edges, or run a zigzag stitch around them, before you begin.
- Wash your hands. Most marks on finished pieces come from hands, not spills.
- Sit in good light. Daylight or a lamp at your shoulder makes the holes easy to see and saves your eyes.
Get the thread ready
- Cut a length about as long as your forearm, roughly 18 inches (45 cm). Longer thread tangles and wears thin.
- The thread has six strands. Pull out one strand at a time, then lay two together. Separated strands lie flat and cover better.
- Thread the needle and leave a short tail. Do not tie a knot: knots make lumps that show from the front.
Make one cross
Think of each square of fabric as having four holes, one at each corner.
- Bring the needle up through the bottom-left hole. Leave about an inch of tail at the back and hold it against the fabric.
- Go down through the top-right hole. That is the first leg: /
- Come up through the bottom-right hole.
- Go down through the top-left hole. That is the second leg, and the cross is done: X
As you make the next few stitches, let them trap the tail at the back. After three or four stitches it is held fast and you can trim it.
Work in rows
For a row of one color, stitch all the first legs across, then come back making the second legs. It is faster, uses less thread and gives a neat back.
The one rule that matters: every cross on the piece must have its top leg leaning the same way. Mixed directions catch the light differently and look uneven.
Follow the chart
A pattern is a grid. Each square with a symbol is one cross, and the key tells you which thread each symbol means. Start in the middle of the chart and the middle of the fabric, so the design ends up centered. Two short guides cover this fully: how to read a chart and how to find the center.
Finish a thread, and finish the piece
When a thread is nearly used up, turn the work over and slide the needle under three or four stitches at the back, then trim. Start the next thread the same way. See starting and ending a thread for the tidy loop start.
When the last stitch is in, wash and press the piece, then mount it in a hoop or frame it.
When something goes wrong
Every stitcher miscounts. The rule is simple: stop as soon as something looks wrong. Five minutes of checking saves hours of unpicking.
- A few stitches in the wrong place: unthread the needle and lift the stitches out one leg at a time with its blunt tip, working backward. Stitchers call this frogging. Do not cut them out unless you must; it is easy to nick the fabric.
- One stitch off, noticed much later: if it does not change the picture, leave it. Nobody will ever see it but you.
- A knot in the thread: slide the needle into the loop and ease it open gently. Pulling tightens it.
- Fabric puckering: your stitches are too tight. Loosen your pull, and use a hoop.
- Lost your place: count from a bold grid line on the chart, not from your last stitch.
Mistakes every beginner makes once
- Pulling too tight. The fabric should stay flat. If the holes are stretched open, ease off.
- Carrying thread across empty fabric. A dark thread dragged across the back shows through light fabric. End it and start again if the gap is more than a few stitches.
- Counting from the last stitch only. One slip moves everything after it. Check your place against a second landmark, such as a bold grid line.
- Twisted thread. Let the needle hang now and then so the thread untwists.
- Leaving the work in the hoop. Take the hoop off when you stop for the day. Left on, it presses a ring into the fabric that is hard to get out.
- Leaving backstitch to the very end of a big piece. If outlining feels like a chore, do it section by section as you finish each area.
Questions people ask
Is cross stitch hard to learn?
No. There is one stitch to learn, and the fabric tells you where to put it. Most people are comfortable within an evening.
How many strands should I use?
Two strands on 14 count Aida. Finer fabric often takes fewer; the chart lists every fabric.
Do I need a hoop?
Not for Aida, which is stiff enough to hold in the hand. A hoop helps on soft fabrics such as linen.
Can children learn cross stitch?
Yes. Use 11 count Aida or larger, a blunt needle, and a small design in two or three colors.
What should my first project be?
Something small in a few colors with no half stitches. Your own name is a good one: type it into the text generator and print the chart.
More guides
- Fabric count explainedWhat 14 count means, and how count changes the size of everything.
- Aida, evenweave and linenHow the three fabrics differ and which to choose.
- How to find the centerTwo reliable ways to start in the middle so the design sits straight.
- How to read a chartSymbols, keys, grid lines and arrows explained on a real chart.
- Starting and ending a threadNo knots: the loop start, the tail start and a clean finish.
- How to wash and pressClean a finished piece and press it without flattening the stitches.
- Cross stitch glossary58 terms in plain words.