Cross stitch guides › Half, quarter and three-quarter stitches
Half, quarter and three-quarter stitches
A cross stitch design is made of squares, which is why its curves look like steps. Part stitches, also called fractional stitches, fill only some of a square, and smooth those steps into slopes. There are three, and each is a piece of the ordinary cross.
The half stitch
One leg of a cross, from corner to corner. It needs no new skill at all. Half stitches are used in two ways:
- For soft backgrounds. Skies, water and distant hills worked in half stitch look lighter and further away than the full crosses in front of them. They also take half the time and half the thread.
- As part of a three-quarter stitch, below.
Slant your half stitches the same way as the bottom leg of your crosses unless the chart shows the other slant. On a chart, a half stitch is a symbol with a slanted line through its square, or a symbol listed in the key as “half stitch”.
The quarter stitch
From one corner to the middle of the square. Come up at the corner and go down in the center. On evenweave and linen, stitched over two threads, the center is a hole, and nothing could be easier. On Aida the center is the middle of a woven block, and the needle has to be pushed through it.
The three-quarter stitch
A quarter stitch and a half stitch in the same square: one short leg to the center and one long leg across. It fills a triangle, three of the square’s four corners, and it is the stitch that turns a stepped edge into a slope.
- Work the quarter first, from the corner to the center.
- Lay the half stitch over it, across the other two corners. The long leg holds the short one down.
How charts show them
A square with a small symbol tucked into one corner holds a part stitch in that corner. If the rest of the square is empty, it is a three-quarter stitch (or a quarter, if the key says so) against bare fabric. If the square holds two small symbols, two threads share it.
The pattern maker on this site draws all three with the pencil, and its PDF charts print a part stitch as an outlined patch with a half-size symbol, with a line on the cover explaining how to read it. How to read a chart covers the rest.
Two threads in one square
Where two colors meet on a slant, the chart gives half the square to each. There are three ways to stitch it, and the chart rarely says which:
- Three-quarter and quarter. The usual answer. Give the three-quarter stitch to whichever color is in front: the petal, not the background; the face, not the sky. The other color gets the quarter.
- Two quarters, when a backstitch line runs along the diagonal between them. The backstitch covers the join, so neither color needs the long leg.
- Two three-quarters. This fills the square most fully and makes a slightly raised stitch, because two long legs cross. Use it when no backstitch will cover the join and both colors matter equally.
Whichever you choose, choose it once and use it throughout the piece.
On Aida: getting through the block
- Use a finer or sharper needle. A size 26 or 28 tapestry needle parts the threads of a block more easily than a 24, and a sharp embroidery needle goes straight through. The needle size chart gives the usual size for each fabric.
- Pierce the center from the front, where you can see it, by working the quarter from the corner in to the middle.
- Wiggle, do not force. The block is made of several threads; the needle will find a way between them.
- If a pattern is full of part stitches, stitch it on evenweave. 28 count evenweave gives the same size as 14 count Aida, and every center is already a hole. Aida vs evenweave vs linen compares them.
How much difference do they make
On 14 count Aida a square is 1.8 mm across. A stepped diagonal moves in jumps of that size; a three-quarter stitch halves the jump. On a small motif seen close, such as a face or a flower, that is the difference between a curve and a staircase. On a large piece seen from across a room it is hard to see at all, which is why many big patterns use whole stitches only. Every pattern in our free pattern library is whole stitches, so none of this is needed to start.
Mistakes that are easy to avoid
- Putting the quarter in the wrong corner. The small symbol’s corner is the stitch’s corner. Check it before the needle goes in.
- Working the half before the quarter. The short leg then lies on top and can lift. Quarter first, half over it.
- Mixing methods for shared squares. A join stitched three different ways looks uneven. Pick one.
- Splitting the thread already there. When a second color goes into the center, slide the needle beside the first thread, not through it.
- Avoiding a pattern because of them. Part stitches are slower than whole ones and no harder.
Questions people ask
What is a fractional stitch in cross stitch?
A stitch that fills only part of a square: a half, a quarter or three quarters. They are used to smooth curves and add fine detail.
How do you do a quarter stitch on Aida?
Come up at the corner and push the needle down through the middle of the block. A fine or sharp needle makes this easy.
Which color gets the three-quarter stitch?
The one in the foreground. The color behind it takes the quarter. If backstitch will run along the join, two quarters are enough.
Is a half stitch the same as a half cross stitch?
Yes. Both mean one diagonal leg of a cross, from corner to corner.
Can I turn part stitches into whole stitches?
Yes, at the cost of a more stepped edge. Give each split square to whichever color has more of it. The pattern maker lets you redraw them before you print.
More guides
- How to backstitchOutlines and fine lines: when to add them, how many strands, and the needle’s path.
- How to do a French knotThe four moves, why knots vanish, and what to use if you dislike them.
- How to cross stitchThe whole craft from the first stitch to the last, for complete beginners.
- Fabric count explainedWhat 14 count means, and how count changes the size of everything.
- Aida, evenweave and linenHow the three fabrics differ and which to choose.
- How to find the centerTwo reliable ways to start in the middle so the design sits straight.
- Cross stitch glossary58 terms in plain words.