StitchAndGrid My projects Make a pattern

Cross stitch calculators › Frame and mat calculator

Cross stitch frame size calculator

Find the mat opening and the frame to order for a finished piece, the nearest ready-made frame, and whether your fabric leaves enough to mount it.

  • Mat opening: the stitching plus the bare fabric you want showing
  • Frame to order: the outside of the mat
  • Nearest ready-made frame
  • Fabric needed to lace ityour fabric is big enoughyour fabric is too small: add a fabric border or use a smaller mat opening
In the unit chosen for spare fabric
Enter 0 for no mat

Your project is kept on this device and follows you to the other calculators.

How to use it

  1. Enter the pattern size and fabric, so the stitched size is known.
  2. Say how much bare fabric should show between the stitching and the mat. A quarter to half an inch is usual; more for a small design in a large frame.
  3. Enter the width of the mat, or 0 if you are framing without one.
  4. Check the last line. It compares the fabric you cut with what a framer needs to pull it tight over a board.

A worked example

A design of 140 × 112 stitches on 14 count Aida is 10 × 8 in.

Mistakes that are easy to avoid

Questions people ask

What size frame do I need for my cross stitch?

Measure the stitched area, add the bare fabric you want to see, then add the mat on every side. The result is the frame size. Without a mat, add at least an inch of fabric all round and order that size.

How much fabric should show around the design?

With a mat, a quarter to half an inch. Without a mat, an inch or more, because the frame itself covers the outer quarter inch.

How wide should the mat be?

Two inches is a common starting point for a piece of about 8 by 10 inches. Small pieces often look better with a wider mat than you expect, and a mat narrower than the frame’s molding tends to look pinched.

Why does the calculator check my fabric?

A framed piece is usually laced or pinned over a stiff board the size of the mat opening. The fabric has to wrap about an inch and a half over each edge. If you cut the fabric too close, it cannot be mounted that way.

Next step